Buch, Englisch, Band 33, 209 Seiten, Format (B × H): 160 mm x 241 mm, Gewicht: 1100 g
Reihe: The Springer International Series in Engineering and Computer Science
Buch, Englisch, Band 33, 209 Seiten, Format (B × H): 160 mm x 241 mm, Gewicht: 1100 g
Reihe: The Springer International Series in Engineering and Computer Science
ISBN: 978-0-89838-244-0
Verlag: Springer US
In the summer of 1981 I was asked to consider the possibility of manufacturing a 600,000 transistor microprocessor in 1985. It was clear that the technology would only be capable of manufacturing 100,000-200,000 transistor chips with acceptable yields. The control store ROM occupied approximately half of the chip area, so I considered adding spare rows and columns to increase ROM yield. Laser-programmed polysilicon fuses would be used to switch between good and bad circuits. Since only half the chip area would have redundancy, I was concerned that the increase in yield would not outweigh the increased costs of testing and redundancy programming. The fabrication technology did not yet exist, so I was unable to experimentally verify the benefits of redundancy. When the technology did become available, it would be too late in the development schedule to spend time running test chips. The yield analysis had to be done analytically or by simulation. Analytic yield analysis techniques did not offer sufficient accuracy for dealing with complex structures. The simulation techniques then available were very labor-intensive and seemed more suitable for redundant memories and other very regular structures [Stapper 80J. I wanted a simulator that would allow me to evaluate the yield of arbitrary redundant layouts, hence I termed such a simulator a layout or yield simulator. Since I was unable to convince anyone to build such a simulator for me, I embarked on the research myself.
Zielgruppe
Research
Autoren/Hrsg.
Fachgebiete
- Technische Wissenschaften Technik Allgemein Konstruktionslehre und -technik
- Geisteswissenschaften Design Produktdesign, Industriedesign
- Mathematik | Informatik EDV | Informatik Angewandte Informatik Computeranwendungen in Wissenschaft & Technologie
- Technische Wissenschaften Elektronik | Nachrichtentechnik Elektronik Mikroprozessoren
- Technische Wissenschaften Technik Allgemein Computeranwendungen in der Technik
- Mathematik | Informatik EDV | Informatik Professionelle Anwendung Computer-Aided Design (CAD)
Weitere Infos & Material
1. Introduction.- 2. Background.- 3. Defect Models.- 4. Defect Statistics.- 5. Fault Analysis.- 6. VLASIC Implementation.- 7. Redundancy Analysis System.- 8. Fabrication Data.- 9. Conclusions and Current Research.- References.
