Tighe / Considine / Kramer Thermomechanics & Infrared Imaging, Inverse Problem Methodologies and Mechanics of Additive & Advanced Manufactured Materials, Volume 6

Proceedings of the 2022 Annual Conference on Experimental and Applied Mechanics
1. Auflage 2023
ISBN: 978-3-031-17475-9
Verlag: Springer International Publishing
Format: PDF
Kopierschutz: 1 - PDF Watermark

E-Book, Englisch, 93 Seiten

Reihe: Engineering (R0)

Thermomechanics & Infrared Imaging, Inverse Problem Methodologies and Mechanics of Additive & Advanced Manufactured Materials, Volume 6 of the Proceedings of the 2022 SEM Annual Conference & Exposition on Experimental and Applied Mechanics , the sixth volume of six from the Conference, brings together contributions to this important area of research and engineering.  The collection presents early findings and case studies on a wide range of areas, including:

Test Design and Inverse Method Algorithms

Inverse Problems: Virtual Fields Method

Material Characterizations Using Thermography

Fatigue, Damage & Fracture Evaluation Using Infrared Thermography

Residual Stress

Mechanics of Additive & Advanced Manufactured Materials

Zielgruppe

Research

Autoren/Hrsg.

Tighe, Rachael C

Considine, John

Kramer, Sharlotte L.B.

Berfield, Tom

Inhaltsverzeichnis

Evaluation of the Maximum Allowable Hole Depth for IHD of GFRP Laminates.- Analysis of Intrinsic Dissipations and Fatigue Behaviour of Steels by Measuring Thermal and Mechanical Signals During Fatigue Tests.- Analysis of the Fracture Mechanics Behaviour of an Additive Manufactured Titanium alloy via a Thermography-based Technique.- Non-Destructive Evaluation of Hot-Spots using the IR Thermography.- Modeling Micrometeoroid and Orbital Debris Impact on Composite Truss Tubes.- Identification of Subsurface Damage in Multi-directional Composite Laminates using Full Field Imaging.- Detection Analysis for Sub-superficial Defects in Additive Manufactured Metal Samples by Means of Flash Thermography.- The Miura Ori Geometry: from Brilliant Theory to Surprising Auxetic Properties.- Flow Visualization in the Extrusion of Highly Filled Polymer Composites for Additive Manufacturing.- Additive Manufacturing of Graded Voronoi Cellular Structures for Increased Design Flexibility.- Investigation of Microstructure and Mechancial Properties of Additive Manufacturing Fabricated Oxide Dispersion Strengthening (ODS) IN718 Alloys.- A Contactless Nondestructive Evaluation Technique to Measure Axial Stress in Continuous Welded Rails.

Über Autor(innen)

Rachael Tighe, University of Waikato, New Zealand; John Considine , United States Department of Agriculture, Forest Service, Forest Products Laboratory, WI, USA; Sharlotte L.B. Kramer , Sandia National Laboratories, NM, USA; Tom Berfield , University of Louisville, KY, USA